This software has the function of the speed internet connection is sometimes slow. equipped with Traffic Shaping technology, the new version this time there is the addition of new features..

* New feature

cFosSpeed 6.50 build 1810 -- 9-Feb-2011

• > cFosSpeed now features packet loss avoidance. Some Internet connections

have a very small packet buffer for incoming data. This buffer is quickly
overrun when too much data is received, leading to packet loss. The packet
loss is then detected by the sending TCP and the rate of transmission is
lowered. Nevertheless, this leads to higher ping times and packet loss
for all data received, even UDP data used for Gaming or VoIP. Tests show
that the packet loss rate can be as high as 5%.

Now cFosSpeed detects this packet loss in TCP streams and keeps the streams
from sending too much data. This avoids packet loss, leading to much lower
loss rates, fewer SACKs and sometimes much better throughput.

The feature is on by default, but can be switched off by setting
"spd gset avoid_loss 0 -save" or switching off "Packet loss avoidance" under
Options, Settings, Preferences.

• > New parameters to set the desired ping delays in both directions: tx_delay,

tx_width, rx_delay and rx_width. cFosSpeed tries to keep the ping between
tx_delay and tx_delay + tx_width when sending and between rx_delay and
rx_delay + rx_width when receiving. The values are in usec. Removed
variable dest_width.

Added delay_auto setting, true by default. If set, it will automatically
set rx_delay and rx_width to sensible values. If you want your own values
in rx_delay and rx_width, you just assign some value to them or switch off
delay_auto.

• > Rx-shaping is now more precise. It limits sending streams quicker to

a proper speed.

• > Tx-shaping has now a better average ping time, since cFosSpeed doesn't try to

increase the send speed so often, much less so in low latency mode. This
lowers average ping time by about 8 msec in pure upload tests here.

• > Added Bulgarian language. That makes a total of 29 languages supported.

• > Increased installation speed.

• > Even if "Automatic MSS (MTU) optimization" is off (default), a set mss_limit

and the intrinsic limit of the medium (like 1492 for PPPoE) will be used to
change the MSS. Therefore, it's good to set the medium properly. Plus,
it helps rx-shaping.

• > Classes can now have -tos switch set to set TOS byte on all outgoing

packets. Since TOS and DSCP both are stored in the same byte, they are
incompatible to one another: you can not use both at the same time.

• > Added dumping of TOS values for "spd dump ...".

• > Added "spd vari" command to show variance sample data. It accepts parameters

-clean to force cleaning of old values, -clear to clear all values and -set
to force use of the calculated variance.

• > Added SACK statistics in "spd netstat" and "spd perf on" output.

• > Added "nsclear" command to clear the "netstat" counters.

• > Added filter expressions -l, -r, -l-mynet, -r-mynet, -l-bcast, -r-bcast,

-l-iplist and -r-iplist. They work like the -s and -d, etc. pendants, just
for local and remote addresses, i.e. invariant of the direction of traffic.

• > Added gset variable "max_hops" (default 8) to allow cFosSpeed to ping with

higher TTLs. Allowed TTL values are 8 - 16. If you change it, you should
use "spd pingboot" afterwards. Thanks to gj090879 for inspiration.

• > Added global variable "vari_trace". When switched off new variance data is

no longer dumped to trace.txt; that is the default now.

• > Added information about cFosSpeed ports to "Options", "Settings",

"Adapter Info" dialog.

• > Fixed a bug in RWIN calculation of rx-shaping. Fixed another bug in rx_limit

code and other fixes in rx-shaping.

• > Fixed a serious bug that affected TCP volume counting of sent traffic.

Thanks to Toxic for his trace.

• > Setting a new iplist name under preferences didn't read the IPlist into

memory right away, but only on the next start. Fixed. Thanks to Laurentius
Węckowski for bug report.

You can list all loaded IPlists with the command "spd showiplists".

• > Fixed a problem where variance would not be properly calculated after pinger

was changed. Thanks to Gothico for the trace.

• > Fixed another bug that affected volume counting when net_talk was enabled,

but no other user was using cFosSpeed.

• > Fixed bug in medium settings for media cable, frame_count, cable_mixed, 3g.

• > Fixed a problem where cFosSpeed could cause too much delay in tx direction.

• > "spd set ..." settings made on the command line would be lost if changes were

made in the HTA applets afterwards. Fixed. Thanks to Toxic for his tests.

• > Fixed a problem where maxtxraw might become too large. Thanks to

Toxic for the trace.

•  Setting msslimit to 536 with medium PPPoE had no effect. Fixed.

• > Removed the additional up to 4 pings per second; it's again sending only 2

pings per second.

• > Fixed a freeze with WLAN cards. Thanks to Stefan Goerick for his dump.

• > Switching an adapter On/Off didn't bind/unbind it immediately. Fixed.

• > The TCP MSS will no longer be lowered if the medium "adaptive" is set. If

you know the type of your connection, set it properly under Options,
Settings, Traffic Shaping, , Options. If you have some DSL variant
cFosSpeed might reduce the TCP MSS on your connections to gain up to 3%
speed if "Automatic MSS (MTU) optimization" is switched on.

• > Fixed some erroneous UTF-8 BOMs in settings.ini.

• > Fixed a problem where data would sometimes not be written properly to

data.ini.

Download cfossped 6.51.exe